FP 25/30/38/50 E
Issue: 06/2011
78
6 .4 .4 Changing the 35 mm Film Runner Strips
Film runner strips (2)
Ceramic rollers (2 per strip)
Knurled fastening screws (4)
• Loosen the knurled fastening screws
and remove the old runner strips
and insert the new runner strips.
$
They must lay in parallel to the
vertical film gate edges.
The small spring-suspended
ceramic rollers must have a free
clearance.
$
The seat is correct, if the conic
ending running strips are lying lightly
on the sprocket without touching
the teeth, so that a perfect film run
even with splices is assured in both
directions.
• Tighten the knurled screws.
6 .4 .5 Adjusting the Lens Holder
• For setting up lenses, set scale in the
mid-position.
• Loosen the clamping screw (arrow)
and push the lens into the holder until
picture is sharp (basic adjustment).
• Tighten the clamping screw again.
• Repeat the adjustment for each lens
without turning the focus knob.
• To adjust the picture focus finally turn the knob slightly as required.
1
2
3
Summary of Contents for FP 25 E PREMIERE
