6
Ballast Operation
The Kamio Ballast
(BAL-149X)
operates remote from the fixture. Connect the
Kamio lamp harness to the extension cable or the Ballast, making sure to rotate
the locking ring until it clicks into the locked position. After the lamps are properly
installed, the Ballast can be turned on. Avoid operating in temperatures above
125
°
F (51
°
C).
(Note: The dimmer should be full up when striking the lamp. Once the lamp has
come up to full temperature, in 3-5 minutes, then dim to the desired light level.)
It is normal for the lamp to take 1-2 seconds to ignite. In cold temperatures the
Ballast may take longer to ignite the lamp. If it does not ignite within 5 seconds,
switch the ballast to OFF, and try again. If lamp does not strike after 2 or 3
attempts, turn Ballast off, check that the harness or any extension connections
are secure and restrike.
CAUTION: For AC operation use the PWS-153X or PWS-137X universal power
supply. Do Not operate Camera and Kamio off a Camera Battery Charger.
The combined load exceeds the Charger’s capacity and will result in the
Charger failing.
Changing Lamps
Extract the lamp by pushing the lamp
harness through the reflector. The lamp
will clear the reflector making it easier to
grasp.
To Ensure Proper Operation
ALWAYS TURN
OFF
THE BALLAST BEFORE connecting or disconnecting lamps,
harnesses or Head Extension Cables. Maximum distance, 30ft (2 x 15ft cables).