Kingtel KT52IP, User Manual

Page: 9 / 81

Auto answer
Contact
DND(Do not Disturb)
In hand free mode
In handset mode
SMS
Missed call
Call forward
1.6 LED Introduction
1.6.1 Power Indication LED (Power Light Enabled)
LED Status Description
Steady red Power on.
Blinking red There is an incoming call.
Off Power off.
1.6.2 Power Indication LED (Power Light Disabled)
LED Status Description
Blinking red There is an incoming call
2 Initial Connection and Setting
2.1 Connecting the phone
1. Connect to the network. Use the Ethernet cable in the package to connect the WAN port
on the back of your phone to an Ethernet port. The following two figures show
connection options.
a. Direct network connection—This method requires at least one available Ethernet port.
Connect the WAN port on the back of your phone to the Ethernet port. Since the phone
has a built-in router, it can be connected directly to the network.
b. Shared network connection—Use this method if you have a single Ethernet port which is
already in use. Disconnect the Ethernet cable from the Ethernet port and attach it to the