Kingtel KT52IP, User Manual

Page: 20 / 81

5.12 Auto Redial
If Auto Redial is enabled, the phone will continue to retry a busy call. The user sets the retry
interval and the number of times to redial. The user is also given the option to activate this
feature on each busy call.
1. Press Menu ->Features-> Enter->Auto Redial-> Enter.
2. Use vol-/vol+ to Enable.
3. Use Up/Down key to select Interval and Times.
4. Press Save.
5.13 Call completion
This is similar to Auto Redial except that it detects the state of the called number before
making a new call attempt.
1. Press Menu ->Features-> Enter->Call Completion-> Enter.
2. Use vol-/vol+ to Enable.
3. Press Save.
5.14 Power Light
T
his feature enables the power light at the bottom of the phone.
Press Menu ->Features-> Enter->Power LED-> Enter.
5.15 Hide DTMF
This feature sets how DTMF digits are displayed after a call is in progress. For example, dial
a PIN code to access banking information.
1. Press Menu ->Features-> Enter->Hide DTMF-> Enter.
2. Use vol-/vol+ to select one of the following 4 choices.
a) Disabled – All the digits will be shown on the LCD.
b) All – None of the digits will be shown on the LCD. The “*” will be shown.
c)
Delay – The last digit entered will be shown for a short time and then replaced by
“*.”
d) Last Show – The last digit entered will be shown. Previous digits are replaced by
“*.”
5.16 Password Dial
This feature controls the display of dialed digits. When enabled, a password and length can
be set.
Example: A call is placed to 6625551212. Password is set to 662 and length is set to 3.
Display will show 662***1212.
1. Press Menu ->Features-> Enter->Passwd Dial-> Enter.
2. Use vol-/vol+ to enable the feature.
3. Use Up/Down key to move to Prefix.