Kingston Technology MobileLite Wireless G2, Setup Manual

Page: 18 / 103

18
Wi-Fi Access Point
Accessing the Internet via the Ethernet
Port (Hotspot)
If you have a wired Internet connection, you can plug an
Ethernet cable into the Ethernet port on the Kingston
MobileLite Wireless G2. This would allow you to create a
hotspot for wireless Internet access. While connected to the
Ethernet bridge mode the Wi-Fi bridge mode will be disabled
temporarily until the Ethernet cable is removed.
NOTE: Only compatible with DHCP.
Simply connect an Ethernet cable to the Ethernet port. Check
that bridge LED is ON to verify that you have a successful
connection to the router. See Figure 10.1 .
If you haven’t already, make sure to connect to the MLWG2 in
your iOS device’s Wi-Fi settings.
Settings App --> Wi-Fi option --> Choose a Network -->
Select MLWG2-XXXX
Additional Features
If you would like to learn how to use some of the additional
features of your 5-in-1 Mobile Companion, visit kingston.
com/MLWG2 and select Technical Support on the page.
Our support site will show you information about:
• Setting up additional wireless settings such as the
security, visibility, channel settings and SSID
• Accessing the Internet by bridging to a
wireless network
• Which 3G USB dongles are compatible for
Internet connectivity
• Connecting to the 5-in-1 Mobile Companion wirelessly
from a PC
• Other info such as the datasheet, warranty information
and available firmware updates
Figure 10.1: Bridge LED