ASSEMBLY INSTRUCTIONS FOR THE TN-55
LEG ASSEMBLY
TABLE TOP
NOTE:
A TENON
B MORTISE HOLE
HARDWARE
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match all joints with the corresponding letters
or numbers stamped on the furniture.
STEP-II
Fit the LEG ASSEMBLY mortise holes onto the TABLE TOP tenons as shown in the
photographs. If necessary, gently rock the LEG ASSEMBLY while pushing tenons into the
mortise holes until joints fit snugly (use of a rubber mallet may be needed). Make sure to
match the numbered tenons with the corresponding mortise holes. Slide the split washers,
followed by the flat washers onto the Knock-Down bolts and tighten with wrench key
provided, as shown in photographs.