KINGSLEY BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE CB-53/60
BACK
PANEL
BOTTOM
FRONT
PANEL
LEFT & RIGHT SIDE PANELS HANDLES
LID
* NOTE:
A TENON
B MORTISE HOLE
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE:
During assembly of the furniture please match all joints with the corresponding
letters or numbers stamped on the furniture.
STEP-II
Carefully place the BACK PANEL on a smooth, flat surface with the
mortise holes facing up. Matching the stamped numbers on the tenons
with those next to the mortise holes, gently insert the LEFT and RIGHT
SIDE PANELS and the BOTTOM into position as shown in the
photograph.
STEP-III
Fit the FRONT PANEL over and onto the exposed tenons and using a
rubber mallet, drive all joints together evenly. If you use a hammer, put
the sanding block between the hammer head and the wood to prevent any
damage or marring of the wood.
STEP-IV
Drive locking dowels into place with a hammer. Use the sanding block
between the hammer head and the dowel to prevent marring of the wood.
If dowel protrudes above the wood, sand it level with sanding block
provided. Make sure to sand along grain of the wood. DO NOT FORCE
DOWELS.
HYDRUALICS
KD BOLTS
