Installation Instructions for
LED Rechargeable Work/Flood Lights
- LEDFLP
10
& LEDFLP
20
PLEASE ENSURE YOU READ THESE
INSTRUCTIONS BEFORE COMMENCING
ANY INSTALLATION
IMPORTANT
Both the
8
W (LEDFLP
10
) and
16
W (LEDFLP
20
) fittings are
portable/rechargeable SMD flood lights. The internal rechargeable
and cordless operation allows for complete portability.
• Do not look directly at the LED lights, this may cause eye injury.
• To reduce the risk of electric shock, do not submerge the units or
its accessories in any liquid. Units are water resistant (IP
65
) but
NOT waterproof.
• Store unit in a clean dry place.
• Protect LED lens from damage and scratching.
CHARGING THE BATTERY
Mains Charger
:110
V-
240
V AC
Car Charger
:
12
V DC
1
. Plug the DC output plug from either adapter into the DC IN
PORT of the unit and then plug the
110-240
V AC or the
12
V DC
adapter into the appropriate electrical socket (depending on
which charger is being used).
2
. Unplug chargers after a full charge is achieved (approx
5
hours
with
110-240
V mains charger).
3
. Can also be operated directly from the mains charger. (When
fully discharged the battery may require
5
minutes of charging
to restart operating with
100-240
V AC charger).
WORK LIGHT OPERATION
.
1.
To attach it to the BASE, remove the MOUNTING BOLT and
place the light on top, aligning the hole in the mounting bracket
to the hole in the base. Replace the bolt and tighten securely.
2
. Toggle switch for ON/OFF operation: (l) for ON and (O) of OFF.
3
. Adjust the angle of the light by grasping the PADDED HANDLE
and tilting the face of the flood light up and down or swiveling
right to left.
LEDFLP10 20 Ins.qxp_Layout 1 13/10/2014 11:24 Page 1
