Instructions for Wired
Doorchimes & Bell Pushes
MODEL NUMBERS -
Doorchimes -
DH
020
A-C Galaxy Chime
DH
021
A-C Tubular Chime
These products should be installed by a
competent person and in accordance with
the current IEE Wiring Regulations.
If in doubt, consult a qualified electrician.
Bell Pushes -
If you have bought a bell push only please
go straight to step
3
a. in these
instructions.
DP
010
A-C Black Bell Push
DP
020
A-C White Bell Push
DP
050
A-C Brass Plate Bell Push
DP
050
AC-C Chrome Plate Bell Push
DP
080
A-C Brass Bell Push
DP
220
A-C White Bell Push
DPL
12
A-C - Illuminating Button insert
Brass
DPL
13
A-C Illuminating Button insert
Silver
(for DPL
12
A-C & DPL
13
A-C please also
note step
3
b)
DPL
03
A-C Illuminating Black Bell Push
DPL
04
A-C Illuminating White Bell Push
(DPL
03
A-C & DPL
04
A-C must be used with a
bell transformer)
This doorchime has a traditional
ding-dong sound and is easily fitted
for use with any bell push.
• Bell wire required
• Bell push required
An ornate bell push can be used if
preferred. (For illuminating bell pushes
a transformer must also be used -
KingShield model number DAT
01
A)
• Fixing screws included
• Requires
3
x C cell LR
14
batteries
(not included)
PLEASE READ THE FOLLOWING
INSTRUCTIONS FULLY BEFORE
ATTEMPTING INSTALLATION.
1
. Using a knife, carefully split the bell
wire down the middle to form two
separate wires, each
30
mm long.
2
. Strip each wire back to expose
5
mm of copper wire.
3
. The process will need to be
repeated at the other end of the
bell wire once it has been cut to
the required length.
1
. PREPARING BELL WIRE
2
. WIRING
YOUR DOORCHIME
3
a. WIRING
YOUR BELL PUSH
4
. The bell wire is now
ready to wire up the
doorchime to the bell
push.
1.
Unclip top cover.
2.
Thread bell wire from the back of
the base and through the large
opening to the left of the keyhole
slot.
3.
Insert either one of the stripped
ends to terminal A and the other to
terminal C, ensuring the terminal
screws are tightened securely
afterwards. Do not use terminals
marked B and D.
4.
Position the base on the wall
vertically, away from opening
doors, with the battery
compartment at the bottom.
Ensure that it is less than
5
metres
away from the bell push.
5.
Use one of the screws and wall
fixings to hang the base on the wall
via the top keyhole slot. Adjust the
screw for a flush fit if required.
6.
Insert
3
x C cell batteries as per
markings on the inside of the case.
1.
If necessary, remove the base
cover of the bell push to reveal the
terminal screws.
2.
Loosen one of the terminal screws
and wrap one of the stripped ends
of bell wire around the exposed
screw thread, ensuring the screw
is tightened securely afterwards.
Repeat this process for the other
screw terminal and wire.
Mar 14.qxp_Layout 1 08/04/2014 12:03 Page 1
