MODEL CAT
01
TV OVER CAT5 DISTRIBUTION AMPLIFIER
The CAT01 is a high output distribution amplifi er specially designed to distribute TV signal over CAT5/6 cable.
The amplifi er has four separate RJ45 outputs each with an individual gain control. The amplifi er also has an
overall gain and tilt control.
INSTALLATION
Connect the RF signal to the RF input of the amplifi er.
Note:
If the input signal is to low it may be necessary to install a pre- amplifi er
(MDA20H and KPS06 power supply).
Connect the DC power supply to the DC input socket.
Make an overall loss calculation for each of the CAT5 cables to be connected, the loss per 10 metres is
approximately 6 dB (CAT6 @ 700 MHz). Adjust the respective output gain controls to compensate for losses
in the cable.
Connect CAT5/6 patch cables to the outputs of the CAT01.
Note:
Ensure to leave the terminators in place on any ports that are not to be used.
Adjust the overall gain and tilt controls to the required output.
Connect your television to the RJ45 wall socket which has been fed RF signal via the CAT01 using a KLE02
Balun transformer cable. Repeat for all televisions you wish to connect to the CAT01.
Once all televisions are connected fi ne adjust the output gain controls if required for optimum performance.
INSTALLATION MANUAL
Specialists in TV signal amplifi cation
46984-1 CAT01 Manual
Includes FOLD LINES - DO NOT PRINT
Total 120 mm wide by 200 mm high double sided
Folds at 40 mm intervals
80 gsm - One colour - Black 100%
RECOMMENDED SIGNAL LEVELS dBuV
Number of channels
42 10
2
Measurement location
Min input level dBuV
63 63
63
Input RF signal
Min output level dBuV
87 87
87
KLE02 connected to output
Max output level
96 102 111
KLE02 connected to output
ACCESSORIES
19” mounting panel with blanking plate KB02
KLE02 Balun transformer cable
Terminator PL041
46984-1_CAT01_manual.indd 1
24/05/13 5:14 PM
