Page 13
(SPECIFICATIONS cont.)
The term “IC” before the radio certification number only signifies that Industry
Canada technical specifications were met.
Each signal booster is individually tested and factory set to ensure FCC
compliance. The signal booster cannot be adjusted without factory
reprogramming or disabling the hardware. The signal booster will amplify, but not
alter incoming and outgoing signals in order to increase coverage of authorized
frequency bands only. If the signal booster is not in use for five minutes, it
will reduce gain until a signal is detected. If a detected signal is too high in a
frequency band, or if the signal booster detects an oscillation, the signal booster
will automatically turn the power off on that band. For a detected oscillation
the signal booster will automatically resume normal operation after a minimum
of one minute. After five such automatic restarts, any problematic bands are
permanently shut off until the signal booster has been manually restarted by
momentarily removing power from the signal booster. Noise power, gain, and
linearity are maintained by the signal booster’s microprocessor.
The manufacturer’s rated output power of this equipment is for single carrier
operation. For situations when multiple carrier signals are present, the rating
would have to be reduced by 3.5 dB, especially where the output signal is
re-radiated and can cause interference to adjacent band users. This power
reduction is to be by means of input power or gain reduction and not by an
attenuator at the output of the device.
This device complies with Part 15 of FCC rules. Operation is subject to two
conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may
cause undesired operation. Changes or modifications not expressly approved by
weBoost could void the authority to operate this equipment.
