8
drilling the installed hole.
2). Stick the EVR stripe attached along the sides and seal the surface with glue;
3). Make the four fixing bolt tight, ensuring the gap 22mm for discharging between lower
surface of the unit and top surface of the van. Observe the deforming of the assembly seat.
Adjust the thickness of shock absorber rubber gasket for leveling.
4). Observe the installation of the air return outlet from the carriage. Seal the seat, EVR,
joints of the top van, ensuring no leakage from the top van.
Figure 4
7). Connection cable
Figure 5 is the connection of power supply. It is connected with insert and interior
channel.
Connect the adaptors properly as shown in Figure 5.