STEP 1:
Verify all components and parts are included.
STEP 2:
Install the KING Jack Antenna in one of two ways (Page 2):
• RV Mounting:
Mount to a bat wing style retractable arm using the supplied RV Antenna Bracket.
• Pole Mounting:
Mount to a stationary pole (on a house for example) using the supplied Pole Mount Bracket.
DO NOT MOUNT TO A POLE ON A VEHICLE.
STEP 3:
READ THE FOLLOWING INFORMATION CAREFULLY, THEN MAKE CONNECTIONS ON PAGE 3.
The KING Jack antenna is an amplified antenna that re12 volts power.
STEP 4:
Read the OPERATING INSTRUCTIONS on page 4 for antenna pointing instructions.
Page 1
When using an existing power injector already in the RV
When replacing an existing amplified antenna that has an existing power injector, just replace
the antenna head assembly and verify that you have power to the KING Jack antenna when the
wall switch power injector is “ON.” A red LED light on the bottom of the KING Jack antenna will
illuminate when +12 volts is present and the internal amplifier is powered. Do not use both the
existing power injector and the power injector supplied with the KING Jack Antenna!
Using two power injectors in the circuit can cause the KING Jack Antenna
power supply to overheat, possibly causing injury or severe damage.
Use either the existing power injector or the KING Jack power injector.
WARNING: DO NOT USE BOTH POWER INJECTORS!
A typical power injector for an
existing RV antenna will be a wall
plate or an A/V distribution box with
an ON/OFF type switch.
When using the KING Jack antenna with the supplied power injector
Verify that any existing power injector has been disconnected.
VHF + UHF Amplified HDTV Antenna
Model OA8000 & OA8001 Installation Instructions
Working: DC12V / 100mA
Input: AC110-120V / AC220-240V
Voltage
Reception Frequencies
VHF: 47-230 MHz
UHF: 470-860 MHz
