E
PI
S
ENSOR
2
U
SER
M
ANUAL
D
OCUMENT
305801,
R
EVISION
A
Pushbutton Switch and Status LEDs:
Local selection and display of full-scale range,
AUTOZERO, and CAL status
Full-Scale Range Remote Signaling
Mass Position Interface:
Range-dependent voltage output on traditional broadband
sensor mass position lines
Signal Line Interface:
Time/Amplitude-coded pulse train superimposed on differential
signal lines: signaled upon full-scale range change, or upon power-ON reset
Electrical Interface
Connector:
Souriau 851-07C16-26P50-A7-44 Receptacle
Acceleration Output:
Up to 40 Vpp differential
Output Impedance:
Under 2 x 100 Ohms
Calibration Input:
Protected, differential input for exciting all three axes simultaneously;
+/-15V Peak; acceleration-equivalent stimulus
Cable:
Right-angle molded plug connects to sensor; Inbound end connects directly to
Q330-class digitizers; Y-plug for RS-232 interface
Physical and Environmental
Housing:
Epoxie-painted, Ni-plated Aluminum; scratch and crack resistant
Leveling:
Integrated bubble level and fine-pitch, adjustable leveling screws
Mounting:
Single, central bolthole passing through sensor; non-interfering with leveling
Size:
5.0”L x 5.25”w X 3.25”H (12.7 cm x 13.3 cm x 8.3 cm)
Weight:
4 Pounds
Operating Temperature:
-40°C to 60°C
Storage Temperature:
-65°C to 75°C
Humidity:
0 to 100%
Weather Resistance:
O-ring sealed to IP-67+
RS-232 Remote Commands (password-protected access)
Full-scale range setting
Calibration ENABLE
AUTOZERO ON/OFF
System Response Values
System Information/Serial Numbers/Hardware and Firmware Revisions
Page 20
August 2015