Kinco HP043-20DT, User Manual

Page: 34 / 53

Kinco-HP
User Manual
34
HSC 3
Mode Description I0.6 I0.7
0
Single-phase up/down counter
with internal direction control:SM127.3
Clock
9 A/B phase quadrature counter Clock A Clock B
3.2.3.2 Control Byte and Status Byte

Control Byte
In SM area,each high-speed counter is assigned control byte to save its configuration data:
one control word (8 bit), current value and pre-set (double-integer with 32 bit). Initial value of
current assigned value. If the current value is written in the high-speed counter, it will start
counting from that value. Please see below:
HSC0 HSC1 HSC2 HSC3 Description
SM37.0 SM47.0 SM57.0 SM127.0
Effective electrical level of reset signal
：
0=high
；
1=low
SM37.1 SM47.1 SM57.1 SM127.1
Effective electrical level to start signal ： 0=high ；
1=low
SM37.2 SM47.2 SM57.2 SM127.2 Orthogonal counter rate
：
0=1x rate
；
1=4x rate *
SM37.3 SM47.3 SM57.3 SM127.3 Counting direction:0=Decrease
；
1=Increase
SM37.4 SM47.4 SM57.4 SM127.4 Write counting direction in HSC? 0= NO; 1= Yes
SM37.5 SM47.5 SM57.5 SM127.5 Write new pre-set value in HSC? 0= NO; 1= Yes
SM37.6 SM47.6 SM57.6 SM127.6 Write new current value in HSC? 0= NO; 1= Yes
SM37.7 SM47.7 SM57.7 SM127.7 Allow this high-speed counter? 0=NO; 1= YES
HSC0 HSC1 HSC2 HSC3 Description
SMD38 SMD48 SMD58 SMD128 Current value
SMD42 SMD52 SMD62 SMD132 Pre-set value
HSC0 HSC1 HSC2 HSC3 Description
SM141.0 SM151.0 SM161.0 SM171.0 Use multiple preset value:0=No. 1=Yes.
SM141.1 SM151.1 SM161.1 SM171.1
Preset value type:0=Absolute value.
1=Relative value.