1.3. Selection of the output signal
The selection of the output signal in voltage (0-10 V or 0-5 V) or in current (4-20 mA or 0-20 mA) must be performed with
the transmitter
NOT ENERGISED
and is made with the DIP switch of the electronic board putting the on-off switches as
shown on the table below:
Configuration
4-20 mA
0-10 V
0-5 V
0-20 mA
Combinations
1.4. Protection tip of the sensors
It's extremely unwise to remove the protection tip of our hygrometry probes as the sensitive
element is very fragile even to light contacts. However, if you have to remove the protection tip,
take all possible precautions and AVOID ANY CONTACT with the sensitive element.
To remove the protection tip, unscrew it or unclip it.
6
INTRODUCTION
2 3 4
1
2 3 4
1
2 3 4
1
2 3 4
1
Protection tip
to unscrew
Protection tip
to unscrew
Sensitive
element
Sensitive
element