kim lighting Bell EL 160 Installation Instructions Download Page 1

Bell

Accent / Pathlighter 

Installation Instructions

Reviised 

7

/

16

/10             ECN 100715008             Status 9 Part No. 95617

INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS

IMPORTANT SAFETY INSTRUCTIONS!

WARNING: Fixtures must be grounded in accordance with local codes or the National Electrical Code.

Portable  spear  or  tree  mounts  using  a  cord  and  plug,  must  be  plugged  into  a  receptacle  protected  by  a

Ground Fault Circuit Interrupter (GFCI) in accordance with the National Electrical Code. Failure to take these steps

may result in serious personal injury.  Lighted lamp is HOT!  Do Not touch hot lens, guard, or enclosure.
MAINTENANCE: To maintain light efficiency and prevent fixture overheating, lenses must be kept clean and free

of  dirt,  dust,  leaves,  trash  and  mineral  deposits  from  water.  For  optimum  performance  a  regularly  scheduled

maintenance program should be followed.  DO NOT operate luminaire with missing or damaged lens.
CAUTION:  L.E.D. fixtures are available in 120 volt input or 277 volt input.  Please verify before wiring fixture to

field wires (see lamp label to verify).  KEEP THIS SHEET FOR FUTURE REFERENCE.

Tools Required:

Flat Blade Screwdriver

3/32”

Allen Wrench

Adjustable Wrench

Thread Sealant

1. Run wires through pole and thread

short thread into pole cap.

2. Coat threads with a good sealant

and install pole into desired
junction box.  (Direct burial box for
H.I.D.)

5. Remove screws from lens frame

with a flat blade screwdriver.

6. Install lamp of type and wattage

shown on fixture label & chart.

Do not

exceed maximum watt-

age.  Re-install lens and lens
frame.  (EL167, BN167 shown on
page 2.)

Installation Instructions:

Make certain the electrical supply is 

OFF

before starting fixture installation.

EL160

BN165

6160
6165

4. Make all necessary connections

observing polarity, i.e. green-to-
ground, white-to-common, and
black-to-voltage.

!

EL167
BN167

IMPORTANT!
For L.E.D. fixtures
only,  verify input
voltage .  See
CAUTION above.

3. Position fixture & tighten locknut

with adjustable wrench. 

Par 20

Lamp

!

P.O. Box 60080 

 16555 East Gale Ave.

City of Industry, California 91716-0080

626/968-56

66 • FAX 

626/330-3861

Reviews: