Kilowatt Labs GF-80000-360Vdc-380Vac-3/3, User Manual

Page: 21 / 60

Centauri Energy Server – User Manual Model Number -GF-80000-360Vdc-380Vac-3/3
This manual is subject to change without notice and at the sole discretion of Kilowatt Labs, Inc.
Kilowatt Labs, Inc. | www.kilowattlabs.com
21
3.5 Introduction of Buttons:
3.5.1 Description of Selection Button Function:
The display screen supports two control modes, namely the button control and touch control. The
system default state is in the touch screen input mode, the corresponding operations are available
through clicking the icon on the LCD screen.
Table 8 Description of Selection Buttons
•
Click the “ ” button on any interface to switch to the button control mode, and then press the
“ ” button to return to the touch screen control mode.
•
After clicking “ ” button, the user can move the cursor through pressing “ ” or “ ” button
to choose the required control button and then press the “ ” button for confirmation.
3.5.2 Description of Function Buttons:
Button Symbols Name Functions
INV ON ON button
When this button is pressed, the Energy Server
executes the boot command and then runs
after pressing the “OK” button.
INV OFF OFF button
When this button is pressed, the
Energy Server
executes the shutdown command and the
shutdown operation is effective by pressing the
“OK” button. At this moment, the
Energy Server
and the output shuts down.
SILENCE ON/OFF Beep ON/OFF
The Energy Server alarm is cancelled or activated
by pressing this button.
FAULT CLEAR
Clear the system
fault
Press this button to clear executed abnormal
protection command, the
Energy Server
will
restart and run.
EPO Emergency stop
When this button is pressed, the s
Energy Server
immediately put an end to the power supply.
Table 9 Description of Function Buttons