Sirius Capacitor Module
–
User Manual
Model Number - 3550-48-B-1.7C-M-SD-A-G
This manual is subject to change without notice and at the sole discretion of Kilowatt Labs, Inc.
Kilowatt Labs, Inc. |
26
Low
Charge
Module
When the Module is in standby mode and it
reaches the minimum voltage, the LCD will
display this message every 30 seconds.
When the Module is connected to a load and it
reaches the minimum voltage, the buzzer
alarms, electronic switch will shut down and
LCD will display the message.
Over-
Temperature
When the Module has an Over-Temperature
fault, the buzzer alarms, the electronic switch
will shut down and LCD will display the
message.
Terminal Over-
Temperature
When the Module has a terminal Over-
Temperature fault, the buzzer alarms, the
electronic switch will shut down and LCD will
display the message.
This means that electronic switch has reached
80
o
C.
8.
Trouble Shooting:
Check the indicators on the front panel to determine the state of the Module. A warning state is
triggered when a condition, such as voltage, current or temperature, is beyond design limitations.
When the Module falls outside prescribed limits, it enters a warning state. When a warning is reported,
the Module immediately stops operation.
The possible warning messages are as follows:
Warning Messages
Description
Trouble Shooting
Over-Current (OC)
OC occurs when the current
goes above 125A or when
the Module is short-
circuited. In this event, the
electronic switch will shut
down.
Switch OFF the circuit breaker and
check the continuity across the
Module terminals to find whether
there is a short circuit. In case of a
short circuit, check the operating
circuitry and clear the short circuit.
