Copyright © Changsha KILOVIEW Electronics CO., LTD. All rights reserved
D300
·
User Manual
10
5.2
Network configuration
The decoder has two Ethernet ports. Generally, it only needs to configure the address 1 of network 1 to
work properly. This IP can be used for network streaming and device management. The two ports can be
used as service separation between LAN and Internet or data flow separation between service and
management.
Click "Network" to enter the configuration page. The network interface icon is shown as green to indicate
the normal working state of network, and the network interface icon is shown as orange to indicate the
disconnected state of network.
Each network port can be configured with 2 IP addresses: "Address 1" is configured to be the working IP
of the device; "Address 2" is used as the default management address and device management as well.
Click the "Set" of “Network 1- Address 1” to configure the IP address. You can get your IP address by
"DHCP Dynamic" and "Manual Set". The IP address obtained by DHCP may change, while the IP
address specified manually is fixed for the convenience of device management. IP address configuration
is according to the actual situation of your local network configuration.