Crate Contents
KiloVault
®
LLC • 330 Codman Hill Road, Boxborough, MA 01719 • +1 (888) 218-5924 •
•
3 of 9
Prior to installing your HAB™, please take pictures of the labels on the left side,
including the serial number, serial number barcode, QR code, and MAC
address. Store this information for your records, it is valuable and may be
necessary for system configuration or troubleshooting. Depending on your
HAB’s position, viewing this information after installation may be difficult.
It may be easier to open the tabs at the bottom (along the sides) of the box and
remove the box from the pallet, rather than removing the top lid and lifting the
HAB™ with the handles.
Part
Quantity
1.5-meter HAB™ to HAB™ CAN Bus communication cable (RJ11) Note: If a longer
cable is needed, it can be replaced with any telephone handset cord. RJ11 6
position, 4 conductor, male connectors both ends. Straight through. Maximum
length, 10 feet.
1
1.5-meter HAB™ to inverter Modbus communication cable to support a future
upgrade - Amphenol AT06 6S connector on one end, stripped wires on the other
1
RJ11 Clear Resistor Plug
1
Wall Mounting Plate
1
M8*30 mm Expanding Screw
10
M8*16 mm Bolt
2
28 mm
Strain Relief
2
47.5 mm Strain Relief
1
Solid Vent Replacement Plates
4