16
Remark: Press and hold +/- button to increase the adjustment speed of the
relevant parameters [01]~[99].
4.
Values of Function Preset
Other preset values like bLF, bun……rrF
※
“LoF” preset is OFF.
※
Other function presets are:
Bluetooth: blF, Buzzer: bun, Lock: LcF, Thread disregard setting: uoF, OK All Auto/ Manual
setting: AcF, NG confirm setting: ncF, Clockwise/ Counterclockwise: rrF
5. Screwdriver, LED and BUZZER status description:
Function Name
Screwdriver Status
LED Status Buzzer warning
tone (bun ON)
OK
Fasten is completed and the
screwdriver is stopped
Green light is
ON (up)
1 short tone
OK ALL
Fastening entire workpiece is
completed and the screwdriver is
released
Green light, red
light (up)
1 long tone
NOK
Fasten operation error
Red light is ON
(up)
Keep a short tone
until the trigger
is released
Display Panel
+
Reset to Default Settings:
1. Press “WS+Res” button on the counter panel until “SE3” shows up on the
screen.
2. Your setting will be completed when screen shows numbers of program
set/ screw and hear a “Beep” sound by press “Key ” button from
remote control
3. Press “Res” button again to return to standby mode.
Display Panel
+
Version Confirmation Setting:
1. Press and hold “WS+Res” button on the counter panel until “SE3” shows
up on the screen.
2.
Press “
” button on the remote controller, and the screen will
display the version in full bright light. Press “Save”, after hearing “beep”
sound, completion is confirmed.
Program
P01
P02
P03
P04
P05
Batch Count
n05
n05
n05
n05
n05
Force
F01
F01
F01
F01
F01
Impacts
H10
H10
H10
H10
H10
Limit
LoF
LoF
LoF
LoF
LoF
