Kikusui TOS9200, Operation Manual

Page: 106 / 172

3-68 Basic Operations TOS9200/9201
To change the interval time or the memory number of a step, move the cursor to the
target and make changes using the rotary knob.
Setting the repeat test
To make settings necessary to repeat a test, use the SHIFT + F2 keys, regardless of
the location of the cursor.
Each time the SHIFT + F2 keys are pressed, END and RET alternate.
END: The program ends, the tester returns to the fi rst step and enters the
READY status and.
RET: The program returns to the fi rst step and starts a new test.
3.13.2 Executing a program
• Releasing the START switch when START MOMENTARY is on is equivalent to
pressing the STOP switch. As a result, in a programmed automatic test, the test is
unable to proceed to the next step if the step interval is set to HOLD.
• If the test executes a step with the timer function set to OFF, it is unable to pro-
ceed to the next step.
To run a program, display the program screen (AUTO).
1. Press the AUTO key to display the program screen (AUTO).
2. Using the rotary knob, specify the number of the program to be
recalled. The name of the selected program is displayed to the right of
the program number.
To check the memory contents, press the SHIFT + F1 keys. The cursor
will move to the step number. Using the rotary knob, select a step num-
ber. The test conditions for the selected step are displayed.
3. To run the program, press the START switch.
During the test, “TEST” is displayed and the TEST LED lights up on the indicator.
The step being run is displayed in reverse image.
NOTE
AUTO AUTO
TEST
PRG
05 : KIKUSUI
TOTAL:10
01 ACW00-0.2s
02 DCW00-0.2s
03 IR 00-0.2s
NAME : --UNTITLED--
CH :
1.00
kV
12
A
3.0
s
NORM
INTVL : 0.2 s