Kikusui tos6200, Operation Manual

Page: 20 / 157

2-6 TOS 6200/6210
2 .5 Connecting the A C P ower Cord
The p o we r c or d t h at is p ro vided v ar ies dependin g o n t he des t in at i o n f or t he p ro d u c t
at t he f a c tor y - shipmen t.
• T he AC power cord for 100 V system shown in Fig. 2-3 has a rated voltage
of 125 V AC . I f this AC power cord is used at the line voltage of a 200 V sys-
tem, replace the AC power cord with that satisfying that line voltage.
A n appropriate AC power cord must be selected by qualified personnel. I f
it is difficult to obtain the AC power cord, consult your Kikusui distributor/
agent.
• The A C p o we r c or d inc or p orat es a disc o nnec t in g device c a p a ble o f is o l at in g t he
p ro d u c t f ro m t he A C p o we r line sh ou ld s u ch bec o me necess ar y . C o nnec t i t to a n
e a sily a ccessible elec tr ic a l out le t.
• D o n ot u se t he A C p o we r c or d p ro vided wi t h t he p ro d u c t a s a A C p o we r c or d f or
ot he r ins tru men t s .
Fig. 2-3 AC power cord
P rocedure
1. C heck that the power supply falls within the input line voltage range
indicated on the tester.
2. C heck that the P O W ER switch of the tester is set to O FF.
3. C onnect the AC power cord to the AC L INE connector on the rear panel
of the tester.
Use t he p ro vided p o we r c o de or p o we r c o de t h at is selec t ed by q ua lified pe r-
s o nnel .
4. C onnect the other end of the AC power cord to an electrical outlet.
F or de ta ils o n t he r e ar p a nel , see 3.2, “Re ar Pa nel . ”
W ARNIN G
NOTE
[85-AA-0003]
PLUG:NEMA5-15
Po we r c or d f or 100 V sys t em
R at ed v o l tag e: 125 V A C
R at ed c urr en t : 10 A
[85-10-0840]
PLUG:CEE7/7
[85-10-0790]
PLUG:GB1002
Po we r c or d f or 200 V sys t em
R at ed v o l tag e: 250 V A C
R at ed c urr en t : 10 A