Kikusui TOS3200, User Manual

Page: 10 / 130

10
TOS3200
Contents by Objectives
• What accessories are included?
→
“Checking the Package Contents”
22
• The EUT power cord cannot be con-
nected to the front panel outlet. What is
the workaround?
→
“Using the Terminal Block on the Rear
Panel”
40
• How do I check the operation of the EUT
before testing?
→
“Checking the EUT Operation”
42
• How do I measure the TC (when touch-
ing with my palm)?
→
“Using the Flat Probe (FP01-TOS)”
46
• How do I use the two test leads?
→
“Connecting the Test lead (TL21-TOS)”
43
• How do I check that correct measure-
ments can be made during the prelimi-
nary inspection?
→
“Measurement Check”
100
Preparation
• How do I measure the TC?
→
“Setting Test Conditions of the TC Mea-
surement”
50
• How do I measure the PCC?
→
“Setting Test Conditions of the PCC Mea-
surement”
54
• How do I measure the TC using the exter-
nal circuit for that I was using until now?
→
“Meter Mode Measurement”
67
• How are the measured values are
judged?
→
“Judgment System”
48
• How do I stop measurements while the
EUT is starting up?
→
“Test Wait Time and Judgment”
49
• What is the maximum value during the
measurement?
→
“Maximum Value Hold Function of the
Measured Current (MEAS MODE)”
58
• What is the measured value at the volt-
age that is higher (or lower) than the
actual power voltage supplied to the EUT.
→
“Measured Current Conversion Display
(CONV)”
59
• How do I find when the TOS3200 was
calibrated the last time?
→
“Time Settings and Calibration Manage-
ment”
102
Setting