Kikusui PWX1500H, User Manual

Page: 12 / 131

12
PWX
Connecting the Power Cord
This product is a piece of equipment that conforms to IEC Overvoltage Category II (equip-
ment that consumes energy supplied from a fixed installation).
A power cord is not included with this 1500 W model. Use a power cord that conforms to this
product’s rated AC input voltage and current.
The following specialized power cords are available as options (CE non-compliant).
750 W model
1
Check that the AC power line meets the nominal input rating of the prod-
uct.
The product can receive a nominal line voltage in the range of 100 Vac to 240 Vac at
50 Hz or 60 Hz.
2
Check that the POWER switch is turned off.
3
Connect the power cord to the AC inlet on the rear panel.
4
Insert the power plug into a grounded outlet.
AC5.5-3P3M-M4C-VCTF
For the 1500 W model
WARNING
Risk of electric shock.
• This product is a piece of equipment that conforms to IEC Safety Class I (equipment
that has a protective conductor terminal). Be sure to earth ground the product to
prevent electric shock.
• The product is grounded through the power cord ground wire. Connect the protec-
tive conductor terminal to earth ground.
• Use the supplied power cord to connect to the AC line.
If the supplied power cord cannot be used because the rated voltage or the plug shape is
incompatible, have a qualified engineer replace it with an appropriate power cord that is 3
m or less in length. If obtaining a power cord is difficult, contact your Kikusui agent or dis-
tributor.
• The power cord with a plug can be used to disconnect the PWX series from the AC power
line in an emergency. Connect the plug to an easily accessible power outlet so that the plug
can be removed from the outlet at any time. Be sure to provide adequate clearance around
the power outlet.
• Do not use the specialized power cord with other instruments.