PMX_MULTI
User’s Manual
53
Basic Functions | Memory Function
Recalling settings
You can recall settings from the memory on the measurement display (“SET” not shown) or the setting dis-
play (“SET” shown).
The contents in the memory are recalled to all channels.
If the output is on, the settings are applied to the output the moment they are recalled.
There are two ways to recall settings from memory. One way is to display the saved contents and recall
them after confirming them (CF02:
ON
), and the other is to recall them immediately (CF02:
OFF
).
Displaying the saved contents and recalling them after confirmation
1
Use the CONFIG settings to set the PMX to display the saved contents of the mem-
ory (CF02:
ON
).
2
Press the key of the memory you want to recall from: A (SHIFT+OVP•OCP), B
(SHIFT+CONFIG), or C (SHIFT+LOCK).
The selected memory area (A, B, or C) blinks.
3
Check the displayed settings, and then press SET.
The selected memory area (A, B, or C) changes from blinking to solid. The recalled memory con-
tents (voltage and current) are displayed and applied to the output.
Press LOCAL to cancel recalling.
Recalling the saved contents without displaying them
1
Use the CONFIG settings to set the PMX to hide the saved contents of the memory
(CF02:
OFF
).
2
Press the key of the memory you want to recall from: A (SHIFT+OVP•OCP), B
(SHIFT+CONFIG), or C (SHIFT+LOCK).
The display area shows the selected memory area (A, B, or C), and the settings are recalled.
If you hold down memory key A (SHIFT+OVP•OCP), B (SHIFT+CONFIG), or C
(SHIFT+LOCK), the present settings will be saved to the memory.
