Kikusui PFX2500 Series, Operation Manual

Page: 86 / 144

86
PFX2512
Installing the Volt/Thermometer Unit OP02-PFX
By installing an Volt/Thermometer Unit OP02-PFX in an option slot on the PFX2512, you can
increase the number of voltmeter and thermometer measurement points.
If OP02-PFX units are installed in all option slots, voltage and temperature measurement points can
be expanded to 12 points.
After you remove an OP02-PFX, attach a slot cover over the empty slot using screws.
1
Check that all devices that you will connect are turned off.
2
Touch a grounded metal object (for example, the metal parts of the rear
panel) to discharge any static electricity from your body.
3
Remove the screws that are holding the slot covers in place on the rear panel
to PFX2512, and remove the covers from the panel.
4
Hold the panel area of the OP02-PFX so that the connector area of the printed
circuit board is facing right.
5
Insert the OP02-PFX into the leftmost slot (slot 1) so that the printed circuit
board’s connector is inserted into the connector at the back of the slot.
If you are installing multiple OP02-PFX units, install them from the leftmost slot (from
slot 1 as they are displayed on the rear panel).
6
Insert the OP02-PFX all the way into the slot.
7
Using the screws included with the OP02-PFX,
8
fix the board to the panel.
Be sure to use the included screws.
IO Config,
Test Condition Editor
9
The first time that you install OP02-PFX units after purchase, use the
Test Condition Editor of BPChecker3000 to set the number of OP02-PFX units.
Number of units that can be installed Up to 3 OP02-PFXs
WARNING
• Risk of electric shock. Be sure to turn the POWER switch off before you install an OP02-PFX
or connect the DUT (battery).
• Before installing or removing an OP02-PFX, remove the connector plug that is connected to
the DUT (battery).
Install OP02-PFX units in adjacent option slots starting from the leftmost slot.
To install an EX01-PFX, install the OP02-PFX units in adjacent option slots starting from the
leftmost slot, and then install the EX01-PFX in the open slot on the right.
?
Help
Volt / Thermometer Unit (Option)