Kikusui PFX2500 Series, Operation Manual

Page: 106 / 144

106
PFX2512
Installing the Voltmeter Unit OP03-PFX
By installing an Voltmeter Unit OP03-PFX in an option slot on the SL01-PFX, you can increase the
number of voltmeter measurement points.
If OP03-PFX units are installed in all option slots of the SL01-PFX, voltage measurement points can
be expanded to 64 points.
After you remove an OP03-PFX, attach a slot cover over the empty slot using screws.
1
Check that all devices that you will connect are turned off.
2
Touch a grounded metal object (for example, the metal parts of the rear
panel) to discharge any static electricity from your body.
3
Remove the screws that are holding the slot covers in place on the rear panel,
and remove the covers from the panel of SL01-PFX.
4
Hold the panel area of the OP03-PFX so that the connector area of the printed
circuit board is facing right.
5
Insert the OP03-PFX into the leftmost slot (slot 1) so that the printed circuit
board’s connector is inserted into the connector at the back of the slot.
If you are installing multiple OP03-PFX units, install them from the leftmost slot (from
slot 1 as they are displayed on the rear panel).
6
Insert the OP03-PFX all the way into the slot.
7
Using the screws included with the OP03-PFX, fix the board to the panel.
Be sure to use the included screws.
Io Config,
Test Condition Editor
8
The first time that you install OP03-PFX units after purchase, use the
Test Condition Editor of BPChecker3000 to set the number of OP02-PFX units.
Number of units that can be installed Up to 8 OP03-PFXs
WARNING
• Risk of electric shock. Be sure to turn the SL01-PFX POWER switch off before you install an
OP03-PFX or connect the DUT (battery).
• Before installing or removing an OP03-PFX, remove the connector plug that is connected to
the DUT (battery).
Install OP03-PFX units in adjacent option slots starting from the leftmost slot of SL01-PFX.
?
Help