Kikusui PCZ1000A, Operation Manual, Page: 28 / 100

2-8
PCZ1000A
2.6 Connecting the AC Power Cord
• The PCZ1000A is an IEC Safety Class I equipment (equipment with
protected conductor terminals). To prevent electric shock, be sure
to ground (earth) the unit.
• This unit is grounded through the ground wire of the power cord. Be
sure to connect the power plug to an outlet with an appropriate
earth ground.
• Use the supplied AC cable to connect to the AC power line. If the supplied cable
cannot be used because the rated voltage is different or the plug does not fit the
socket, have a qualified electrician replace it with a suitable cable no more than 3 m
in length. Please contact your local Kikusui agent or distributor if you have any
difficulty in obtaining a suitable power supply cable.
• The power cord and plug can be used to disconnect the unit from the AC power
line in case of emergency. Always plug the cable into a convenient nearby socket
from which you can unplug it quickly if necessary and provide sufficient space
around the socket.
• Please do not use the supplied power cord on any other equipment.
The PCZ1000A is an IEC Overvoltage Category II device (energy-consuming
equipment supplied from the fixed installation).
Procedure for Connecting the Power Cord
1
Turn off the POWER switch.
2
Check that the AC power line is compatible with the input power ratings
of the PCZ1000A.
The PCZ1000A can be used with power supplies with voltages between 100 Vrms and
240 Vrms, and with a frequency of 50 Hz or 60 Hz.
3
Connect the AC cable to the AC inlet (AC LINE) on the rear panel and
plug the other end to an outlet with proper grounding.
Fig.2-5 Grounding
WARNING
To a three-prong outlet
with proper grounding