Kikusui PBZ20-20, User Manual

Page: 45 / 170

PBZ
45
2
Basic Featu
res
Selecting an AC Signal (Internal Signal Source)
This section explains how to set the PBZ to generate an AC signal from the internal signal
source. Switch between setup screens to select the setting that you want to specify. Set the
voltage in CV mode and the current in CC mode.
Depending on the settings, there are five setup screens. Press the AC key to switch between
pages (page 1/5 to page 5/5). If you have used to set SELECT (the signal source
selection) to EXT (an external signal source), pressing the AC key will have no effect.
p. 87
1
Press AC.
The AC key illuminates, and the AC setup screen (1/5) appears.
2
Press AC to select the page that you want to edit.
The page switches.
3
Use the up and down cursor keys to select a setting.
The cursor moves to the setting that you want to specify. You can switch the page by
continuously pressing the up or down cursor key.
4
To enter a number, use the left and right cursor keys to move the cursor
to the digit that you want to specify.
This operation is unnecessary if you are using the numeric keys.
5
Use the rotary knob or numeric keys to specify the value.
Amplitude
t
0
Output
Waveform
Frequency
DC signal
AC signal
Waveform (sine, triangle, square, and user-defined)
Amplitude
Frequency
Start phase
Duty ratio (square waves)
Frequency sweep
CONFIG
See
Cursor
Page