Kikusui KJM6310, Operation Manual

Page: 47 / 56

KJM6310 Maintenance 5-1
Chapter 5 Maintenance
This chapter describes maintenance and inspection of the KJM6310.
Conduct periodic maintenance and inspection to maintain the initial
performance as long as possible.
5.1 Cleaning
If the panel needs cleaning, gently wipe using a soft cloth with water-
diluted neutral detergent.
• Be sure to turn off the power switch before cleaning.
• Do not use volatile solvents such as thinner or ben-
zine. They may discolor the surface or erase the
printed characters.
5.2 Inspection
DC plug: Check for ruptures in the covering, play or cracks in the
plug and so on.
• Breaks in the insulation coating may cause electric
shock. If a break is found, stop using it immediately.
To purchase accessories, contact your Kikusui agent or distributor.
5.3 Calibration
The KJM6310 is calibrated at the factory before shipment. However,
periodic calibration is necessary due to changes that occur after
extended use.
For calibration, contact your Kikusui agent or distributor.
CAUTION
WARNING