Kikusui KHA3000, Operation Manual, Page: 288 / 392

288
KHA3000
IEEE 488.2 Common Commands
*CLS
p. 337
Clears all event registers including status bytes, event status and error queue.
Command
*CLS
*ESE
p. 341
Sets the event status enable register calculated by the event summary bit (ESB) of the status
byte.
Command
*ESE <NR1>
*ESE?
Parameter Value: 0 to 255
An SCPI error (-222, “Data out of range”) occurs if outside the range.
Example: Sending *ESE16 sets bit 4 of the event status enable register. Every time the
execution error bit (bit 4) of the event status register is set, the summary bit (ESB)
of the status byte is set.
Response
Returns the value of the event status enable register in the <NR1> format.
*ESR
p. 341
Queries the event status register. The register that has been read is cleared.
Command *ESR?
Response
Returns the value of the event status register in the <NR1> format and clears the register.
*IDN
Queries the model name of this product, serial number and the firmware version.
Command
*IDN?
Response
A response is returned as follows:
Example: KHA3000, serial number AB123456 and firmware version 1.00
“KIKUSUI, KHA3000, AB123456, 1.00” is returned.
*OPC
IEEE 488.2-1992
Section 12.5.3
Sets the OPC bit (bit 0) of the event status register when the processing of all commands
standing by is complete.
Command
*OPC
*OPC?
Response
Returns 1 when the processing of all commands standing by is complete.
See
See
See
See