Kikusui KHA3000, Operation Manual, Page: 272 / 392

272
KHA3000
Storage Media
p. 88
Both a compactFlash card and a USB flash drive can be use as storage media.
CompactFlash Card
This memory is used to save test conditions and printed reports. It can be inserted and
removed irrespective of whether the POWER switch is on or off.
• A card exceeding 512 MB cannot be used.
• Microdrives are not supported.
• This product operates in 3.3 V True IDE mode.
Insertion
1
Push the cover of the MEMORY slot on the front panel to open the slot.
2
Ensure that the connector part of the CompactFlash card is facing this
product and insert it with the label surface positioned as shown in the
illustration below.
The connector part of this product
is positioned inside. Slowly insert
the card straight and deep. If it is
inserted forcibly or at an angle, a
failure may occur.
Removal
1
Push the lever.
The lever head comes out toward you.
2
Push the lever again.
The CompactFlash card comes out toward you.
See
CAUTION
• Insert only a CompactFlash card and SD-CF adapter; otherwise, the card and this product
may fail.
• To use a new card, be sure to format it with this product. If it is formatted with a computer or
other device, this product may not operate or the CompactFlash card may fail.
Lever
CompactFlash card
Label surface
Card slot cover
CAUTION
• While a file is being manipulated or a report is being output, do not remove the
CompactFlash card. The data may be deleted or damaged.