Kikusui KHA3000, Operation Manual, Page: 213 / 392

9
KHA3000
213
Ex
ecuting V
olta
g
e Fluctuation T
ests
When the Test Time Expires (61000-3-3)
●
When the result of the general judgment is acceptable (PASS,the progress bar is green),
follow the procedure described below.
p. 214
●
When the result of the general judgment is not acceptable (FAIL,the progress bar is red),
set the impedance again and re-execute the test for the 61000-3-11 standard. For details,
see "Setting the Impedance Again (61000-3-11)".
When the General Judgment is PASS
1
Press the F1 key (OK).
The test ending menu shown below is displayed and the buzzer stops.
2
When terminating the test, select an item you want to operate from the
test ending menu.
p. 220
For details on the selection, see "Overview of the Test Ending Menu".
When the General Judgment is FAIL
�
Set the impedance again and re-execute the test for the 61000-3-11
standard.
p. 214
See "Setting the Impedance Again (61000-3-11)".
S ee
Display after the test ends
Test status display
Switches from “ Test ” to “ Analysis. ”
The progress bar extends to the right end and its color changes
according to the judgment.
PASS The result of the general judgment is acceptable (the progress bar is
green).
WARNING The result of the general judgment is acceptable but the margin is
exceeded (the progress bar is yellow).
FAIL The result of the general judgment is not acceptable (the progress bar is
red).
S ee
S ee