Kikusui KHA1000, Operation Manual, Page: 48 / 274

2-18
KHA1000
2.7 Connecting Power Cord
•
To avoid electric shock:
This product is an IEC Safety Class I equipment (equipment with a
protective conductor terminal). To prevent an electric shock, be sure
to ground it.
•
The product is grounded through the power cord ground wire.
Connect the protective conductor terminal to earth ground.
•
To connect to the AC power line, use the accessory power cord.
•
If the accessory power cord cannot be used because of its rated voltage or plug
shape, have a qualified engineer replace it with an appropriate power cord of 3 m
or shorter. If it is difficult to procure the power cord, contact your Kikusui
distributor or agent.
•
A power cord with a plug can be used to disconnect this product from the AC
power line in an emergency. To disconnect the plug from the outlet at any time,
connect the plug to an outlet within your reach and keep sufficient space around
the outlet.
•
Do not use the accessory power cord to operate another device.
This product is designed as an equipment of IEC Overvoltage Category II (energy-
consuming equipment supplied from the fixed installation).
1.
Check that the AC power line to be connected conforms to the input
ratings of this product.
The voltage that can be input is a nominal power supply voltage ranging from 100 Vac
to 240 Vac, and the frequency is 50 or 60 Hz.
2.
Check that the POWER switch is OFF.
3.
Connect the power cord to AC INPUT on the rear panel.
4.
Insert the power cord plug into the outlet.
WARNING
Three-prong outlet where
grounding is provided