Kikusui KHA1000, Operation Manual, Page: 236 / 274

8-44
KHA1000
FETC:VOLT:AMPL:MIN
READ:VOLT:AMPL:MIN
MEAS:VOLT:AMPL:MIN
Each queries the measured value of the minimum voltage (negative amplitude peak
value).
Command
FETCh[:SCALar]:VOLTage:AMPLitude:MINimum?
READ[:SCALar]:VOLTage:AMPLitude:MINimum?
MEASure[:SCALar]:VOLTage:AMPLitude:MINimum?
Effective modes are HA, VF, BASIC, and FFT.
Response
Returns the measured value of the minimum voltage (negative amplitude peak
value) in the <NR3> format.
Unit:
V
8.7.5 Trigger Function
This section explains the commands that set trigger functions. Sequence 1 indicates
the constant measurement state (ACQuire) before start of testing.
INIT
INIT:NAME
Starts the trigger function. The command is invalid if issued during analysis in the
test execution state. In the relevant sequence group, measurement begins
immediately in the case of TRIG:SOUR:IMM. In the case of TRIG:SOUR:BUS,
measurement begins after a software trigger is received. After measurement begins,
the MEAS bit of the OPER register is set, and is reset upon completion.
The INIT command abandons and nullifies the measurement data collected
previously. If an FETC? query is sent immediately after the INIT command is sent,
measurement data is returned after completion of measurement.
Command (Sequence 1)
INITiate[:IMMediate][:SEQuence[1]]
INITiate[:IMMediate]:NAME {ACQuire}
Parameter
Value:
ACQuire Sequence 1: Constant measurement state
before start of testing
INIT:CONT
Sets the automatic continuation mode of sequence operation for Sequence 1. The
command is invalid if issued during analysis in the test execution state.
• When the automatic continuation mode of sequence operation is set to ON
When the parameter of the trigger source of Sequence 1 is IMM, the system
immediately begins measurement. After the measurement is finished, the next
measurement automatically begins.