Kikusui KHA1000, Operation Manual, Page: 122 / 274

5-20
KHA1000
5.3.3 Ignore 5 mA or Below, 0.6 % or Below, End at Over-range,
Margins and Printout of Setting Values, and Class Options
Menu
Use this menu to compare 0.6 % of the input current with 5 mA and specify whether
or not to ignore a harmonic current that is less than the larger of the two. To allow
for consideration of values up to the smaller current, select “Disabled.”
Page 5-46
If the measured value exceeds the set voltage range or current range (overrange), an
error message will be displayed and the measurement will be terminated. However,
the data up to the point when the overrange occurs can be analyzed. The judgment
will be FAIL.
This menu sets the standard limit value as 100. The setting range is 10 to 100. Select
80, for example, when 80 % of the standard limit value is selected.
This value cannot be set during test and analysis.
Table 5-6 Color identification and judgment in graph or list view
Page 4-16
This menu is for outputting the setting value using a specified printout format.
F1
Ignore 5 mA

0.6 %
Enabled Disabled
F 1 F 1
F 2 F 2
F 3 F 3
F 4 F 4
F 5 F 5
F 6 F 6
Page 3/3
F2 Overrange Abort Enabled
See
F3 Margin (%)
Numeric
value
Color
identification
Measured value Judgment
Green
(Graphs only)
Up to the margin setting value PASS
Yellow
Greater than the margin setting value up to the limit
value
WARN
Red Greater than the limit value FAIL
F4 Print Press
See