Kikusui KFM2151, Operation Manual

Page: 47 / 112

KFM2151
3-13
Operation
3.8 Channel Expansion
Up to four slave units can be connected to a single master unit.
The number of channels can be expanded to 160 by using five KFM2151s.
For the connection between the KFM2151 and the KFM2150 FC Impedance Meter,
see “2.4 Connecting the KFM2151 to the FC Impedance Meter.”
Table 3-5 shows the channel numbers when multiple KFM2151s are used.
If you are using a single KFM2151, set it to be the master unit.
Page 3-11
Channel verification works correctly only when the master unit is operating.
Ta b le 3-5 Channel n u m b ers of the master u nit and sla v e u nits
Setting the master unit or slave unit (unit number)
Set one KFM2151 to be the master unit (unit number: 0) and other KFM2151s to be
slave units (unit number: 1 to 4).
Page 3-12
1.
Select parameter n u m b er 010 in the CO N FIG settings.
2.
In the condition setting, set the master u nit to 00 and sla v e u nits to 01,
02, 03, or 04.
3.
T u rn the PO W ER s w itch off and then t u rn it b ack on.
See
Master/Sla v e Unit Nu m b er Channel Nu m b er
Master u nit
(factory defa u lt)
0 001 to 032
Sla v e u nit
1 101 to 132
2 201 to 232
3 301 to 332
4 401 to 432
See