KFM2151
3-7
Operation
Setting the impedance channels
1.
Check that the KFM2151 is in monitor mode.
If the CHANNEL display or VOLT/TERM display is blinking, press the MON key.
2.
Press the IMP/
V
OLT key.
Select IMP.
The IMP LED and VOLT LED illuminate alternately each time you press the IMP/
VOLT key.
3.
Press the SET key.
The CHANNEL display blinks.
4.
Press the
and
keys or SHIFT+
and
keys to select the
channel.
5.
Press the SET key.
The VOLT/TERM display blinks.
6.
Press the
and
keys to select the scanned so
u
rce (O
N
/OFF).
7.
Press the SET key.
The CHANNEL display blinks.
8.
To set other channels, repeat steps step 4 to 7 . To finish, press the
MO
N
key.
Summary of Contents for KFM2151
