Kikusui KDS6-0.2TR, Operation Manual

Page: 54 / 60

50 Specifications KDS6-0.2TR
6.2 General Specifications
Item Specifications
Remote interfaces GPIB Conforming to IEEE Std.488-1978
SH1, AH1, T6, TE0, L4, SR1, RL1, PP0, DC1, DT0, C0, E1
RS-232C Connector 9-pin D-Sub terminal on rear panel
Bit rate 2400, 4800, 9600, 19200, 38400 bps
Data bit 8 bits
Stop bit 1 bit
Parity bit None
Flow control Provided (XON/XOFF)
Temperature and humidity range for guaranteed
specifications 23ºC ± 5ºC
20% RH to 85% RH (without condensation)
Operating temperature and humidity range 0ºC to 40ºC
20% RH to 85% RH (without condensation)
Storage temperature and humidity range -10ºC to 60ºC
90% RH or less (without condensation)
Line voltage range
(AC 50/60 Hz) Voltage
setting 100 V 90 V to 110 V
120 V 104 V to 126 V
220 V 194 V to 236 V
240 V 207 V to 250 V
Power consumption 40 VA or less
External dimensions (largest part) 280W
×
88H
×
270D mm
(305W
×
105H
×
330D mm)
Weight 4 kg
Safety
*1
*1. Not applicable to custom-made products and modified products.
Compliant with the requirements of the following standard:
IEC61010-1:2001
Class I
*2
Pollution degree 2
*3
*2. This is a Class I equipment. Be sure to ground the KDS6-0.2TR's protective conductor terminal.
The safety of this product is only guaranteed when the product is properly grounded.
*3. Pollution is addition of foreign matter (solid, liquid or gaseous) that may produce a reduction of
dielectric strength or surface resistivity. Pollution Degree 2 assumes that only non-conductive pol-
lution will occur except for an occasional temporary conductivity caused by condensation.