Kikusui BIM1000 Series, User Manual

Page: 30 / 94

30
User’s Manual
BIM1000 Series
External Control
SIGNAL I/O Connector
Check the SIGNAL I/O connector specifications, and connect the external device to the connector.
Pin arrangement
If “:SYSTem:ELOCk” (p. 68) is set to ON through remote control, you cannot use the SIG-
NAL I/O connector. If you turn off the product and turn it back on, “:SYSTem:ELOCk” will
be set to OFF and you will be able to use the SIGNAL I/O connector.
No. Signal
name IN/
OUT Description See
1
PM0 IN Enter the memory number (0 to 99) using a 2-digit BCD code
p.34
2
PM1 IN
3
PM2 IN
4
PM3 IN
5
PM4 IN
6
PM5 IN
7
PM6 IN
8
PM7 IN
9
STB IN Recall memories selected with the PM0 to PM7 signals.
p.34
10
– – Not used –
11
– – Not used –
12
– – Not used –
13
COM – SIGNAL I/O common Isolated from the internal circuit and chassis. –
14
OHM-UP OUT Resistance measurement judgment result (UP)
p.33
15
OHM-LO OUT Resistance measurement judgment result (LOW)
p.33
16
– – Not used –
17
V-UP OUT Voltage measurement judgment result (UP)
p.33
18
V-LO OUT Voltage measurement judgment result (LOW)
p.33
19
– – Not used –
20
TRIG-IN IN External trigger input
p.33
21
EOM OUT Measurement end signal
p.32 , p.33
22
INDEX OUT On while measuring
p.32 , p.33
23
– – Not used –
24
ISOVDD – Isolated power supply 5 V dc output
p.31
25
COM – SIGNAL I/O common Isolated from the internal circuit and chassis. –
13
14
1
25
SIGNAL I/O connector pin no.