A
Page 13 / 30
Datasheet 1.10-65.030-01-EN
RPW404P-FTL
Product Description
Issue 2017-04-03
Teaching in the MD15-FTL radio partner on the RPW404P-FTL
!
CAUTION
This product description describes the specific settings and functions of the RPW404P-FTL. In
addition to these instructions, the product descriptions of the radio partners must also be observed.
Up to four MD15-FTL wireless small actuators can be taught-in on the room control module.
►
Switch on the room control module, see page 11.
►
Press the Setting button (01) briefly.
The text “
SERV
” briefly appears on the display, followed by
the “actuator” icon and the text “
ACT
”
►
Press the Occupancy button for approximately 5 seconds.
The “Antenna” icon also flashes on the display.
►
A teach-in radio telegram must be triggered on the MD15-FTL. Details can be
found in the documentation for the MD15-FTL.
►
If multiple MD15-FTL wireless small actuators are to be taught in,
the radio teach-in telegrams must be triggered consecutively.
The number of taught-in wireless small actuators is displayed for approx. 15 seconds
following completion of the teach-in process.
Once all wireless small actuators have synchronized successfully after the teach-in
process, the “antenna” symbol is also displayed after a further 45 seconds.
Data has been exchanged between the radio partners.
All wireless small actuators must be taught-in within a
single
teach-in sequence.
The time between each wireless small actuator teach-in may not exceed 15 seconds.
The MD15-FTL acknowledges the start of the teach-in process with a signal tone.
Successful registration of the MD15-FTL is acknowledged with two signal tones.
If the teach-in process was successful, the “Antenna”, “Auto” and “Occupancy” icons
are displayed.
The current room temperature is displayed.
!
CAUTION
If the MD15-FTL wireless small actuator acknowledges registration with a downward sequence of
tones (two long tones), this means that an error has occurred and registration has failed. Start the
teach-in process again.
The radio actuators are registered on the RPW404P-FTL. The room control module now starts to
learn the individual utilization time profile.
The room control module controls the room temperature using the default utilization time profile until
is has learned the first utilization time profile.
