A
Page 14 / 28
Product Description
RPW301-FTL
Datasheet 1.10-65.020-01-EN
Issue 2017-12-20 from V3.02
Default utilization time profile:
NOTE
It is not possible to add an additional valve controller after the procedure is complete.
If you want to do this, you must teach in
all
valve controllers again.
NOTE
If the en:key room sensor was already switched on, the item “Switching on the device” is skipped and
the en:key room sensor uses the utilization profile already taught-in.
Mounting
The room sensor can be stuck to smooth, flat surfaces using the wall mount and the adhesive pad
supplied, or it can be screwed directly onto level surfaces.
Screws and wall plugs are not included in the scope of delivery of the room sensor.
WARNING
Flush mounted cabling and piping at the installation location (electricity, gas, water)
Cabling and piping can be damaged by drilling.
Check the installation location for flush mounted piping and cabling, or contact a specialist.
NOTE
Position the wall mount so that the bar (1) can be easily accessed. Ensure a distance of at least 10 cm
from other objects (door frames, electrical sockets, cupboards, etc.).
NOTE
Observe the orientation of the wall mount. The bar (1) must be on the right-hand, lower side when
the device is installed, see figure 4.
Use the enclosed adhesive numbers (2) for precise identification of the mounting location and the
respective room sensor.
►
Mark the room sensor and the wall mount with a unique number using the enclosed adhesive
numbers (2).
Room used:
6:00 AM - 8:00 PM, comfort temperature
Room unused:
8:00 PM - 6:00 AM, economy temperature
