Kidde Fire Systems ARIES NETLink, Installation, Operation And Maintenance Manual, Page: 94 / 294

Installation
February 2012 2-38 P/N 06-237058-001
Figure 2-31. Wiring Diagrams for Solenoid-Based Releasing Devices
On-board R-NAC
Connectors
Ma
in
C
on
tro
ll
er
B
o
a
rd
J17
J18
Expansion Card
R-NAC Connectors (3)
R-NAC 1
R-NAC 2
R-NAC 3
Release Notification-Appliance Connectors
(located on MCB and R-NAC Expansion Card)
R e l e as e C ircuit s - S o l enoid
CLASS A, P ower -L i m ited W iring
R e l e as e C ircuit s - S o l enoid
CLASS B, P ower -L i m ited W iring
R e l e as e C ircuit s - S o l enoid
CLASS B, N on -P ower -L i m ited
S
(Non-Power-Limited when In-Line Device not used)
R-NAC 1 or 2
IN+ IN- OUT+ OUT-
Red Blk
S P
In-Line Releasing Device, P/N 06-220023-001
(Must be close nippled to solenoid enclosure)
R-NAC 1 or 2
IN+ IN- OUT+ OUT-
Red
Blk
n-Line Releasing Device, P/N 76-800000-004
(Must be close nippled to solenoid enclosure)
R-NAC 1 or 2
IN+ IN-
OUT+ OUT-
End-of-Line Resistor,
10K + 5%, 0.5 W
S P
(Keep resistor as close to
connector as possible.)
Installation Notes
:
2. Route non-power-limited wiring at least ¼-in. away from
all power-limited wiring. Place non-power-limited wiring
inside a conduit.
1. Refer to Table C-2 in Appendix C of this manual for nominal
resistance for a specific solenoid-based device.
3. Multiple conductors cannot be used on the terminal blocks.
Multiple conductors are to be connected as depicted above.
T o E nd -Of-L ine
R e s i s tor
T o D e v ice
T o T er m in al
TYPICAL WIRE NUT
CONNECTION