INSTALLATION INSTRUCTIONS
Models: 16070xxx27R
16070xxx30R
SAFETY INSTRUCTIONS
READ THIS FIRST
KEEP THESE INSTRUCTIONS
This fixture is intended for installation in accordance with the
National Electric Code (NEC) and Local code specifications.
Failure to adhere to these codes and instructions may result in
serious injury and/or property damage and will void the warranty.
1)
WARNING:
This fixture is not to be installed within 10 feet
(3M) of a pool, spa or fountain.
2) This fixture is to be used only with a power unit (transformer)
rated a maximum of 300 W (25 AMPS) 15 volts.
3) The #18 ga. fixture wire is not intended for direct burial.
4) Direct burial rated wire is to be buried a minimum of 6”
(152mm) beneath the surface of the ground.
NOTE:
If additional Direct Burial wire is needed, contact
your local Kichler
®
landscape distributor.
• 8 GA wire can be purchased in length of 250’ (76 M),
15503-BK.
• 10 GA wire can be purchased in length of 250’ (76 M),
15504-BK.
• 12 GA wire can be purchased in lengths of 100’ (30 M),
15501-BK; 250’ (76 M), 15502-BK; 500’ (152M), 15505-BK;
and 1000’ (304 M), 15506-BK.
5) Wiring connections must be made with approved/listed wire
connection device(s) suitable for the application. Do not
exceed manufacturers’ wiring combination specifications for
size and quantity of conductors.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS
Lighted lamp is HOT!
WARNING — To reduce the risk of FIRE OR INJURY TO PERSONS.
1) There are no user replaceable components inside the fixture.
2) Do not look directly at lighted lamp.
3) Keep lamp away from materials that may burn.
4) Do not operate the fixture with a damaged or missing lens.
CAUTION
WHEN INSTALLING KICHLER LANDSCAPE LIGHTING (LINE VOLTAGE OR LOW
VOLTAGE), CARE SHOULD BE TAKEN TO KEEP CLEAR OF POTENTIALLY COM-
BUSTIBLE MATERIALS.
WHEN MAINTAINING THE FIXTURES, BE SURE TO REMOVE LEAVES, PINE NEE-
DLES, GRASS CLIPPINGS, MULCH, OR ANY DEBRIS THAT HAS ACCUMULATED
ON THE LIGHT BULB, LENS, OR BODY OF THE FIXTURE.
ASSEMBLY AND INSTALLATION
1) Determine desired location for mounting fixture.
2) At desired location, hammer stake (A) into ground. To avoid
damage to stake, place a board on top of stake while
hammering. If ground is hard and stake is difficult to install,
make a crosscut in ground using a flat shovel.
3) Clear away area in ground at wireway slot (B) in top of
stake (A). Lay 12V cable into wireway slot (B) and screw
stem (C) into stake (A). If assembly does not look straight,
adjust by pushing or pulling on stake only.
4) TURN OFF POWER.
5) Make wire connections using supplied wire nuts following
instructions on bag.
Date Issued: 12/12/14
IS-16070R-US
For warranty information please visit: http://www.landscapelighting.com/portal/warranty_page
Para informacion de la garantia por favor visite: www.landscapelighting.com/portal/warranty_page
C
B
A
We’re here to help
866-558-5706
Hrs: M-F 9am to 5pm EST
