SPS Smart Profiler Hardware Guide
PTG-330310-000 Rev. C
19
Regulatory Compliance
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC
Caution: Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
To comply with FCC RF exposure requirements a separation distance of at least 20 cm must be
maintained between this device and all nearby persons.
Industry Canada
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son
fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer
d'interférences et (2) cet appareil doit accepter toute interférence, y compris celles pouvant causer un
mauvais fonctionnement de l'appareil.
This device complies with Health Canada’s Safety Code. The installer of this device should
ensure that RF radiation is not emitted in excess of the Health Canada’s requirement. Information can be
obtained at
http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guide-lignes_direct/index-eng.php
To comply with ISED RF exposure requirements a separation distance of at least 20 cm must be
maintained between this device and all nearby persons.
Cet appareil est conforme avec Santé Canada Code de sécurité 6. Le
programme d ’installation de cet appareil doit s’ assurer que les rayonnements
RF n’est pas émis au-delà de I’exigence de Santé Canada. Les informations
peuvent être obtenues:
http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guide-lignes_direct/index-fra.php
Pour satisfaire aux exigences d’exposition aux RF ISED une distance d’au moins 20 cm doit être
maintenue entre cet appareil et toutes les personnes à proximité.
