Kia XCeed 2020, Owner'S Manual, Page: 404 / 725

6
Driving your vehicle Forward collision-avoidance assist (FCA)
(Radar type)
6
77
the sensor cover or sensor is clean
and free of dirt, snow, and debris.
Dirt, snow, or foreign substances on
the lens may adversely affect the
sensing performance of the sensor.
Warning message and warning
light
OJF058392L
When the sensor cover is blocked
with dirt, snow, or debris, the FCA
operation may temporarily stop.
In this case, the warning message
appears to warn the driver.
This is not a malfunction with the
FCA. To operate the FCA again,
remove the foreign substances.
The FCA may not properly operate
in an area (e.g. open terrain), where
any substances are not detected
after turning ON the engine.
WARNING
The FCA system may not activate
without any warning messeges
according to driving condition, traffic
on the road, weather, road condition,
etc.
NOTICE
• Do not install any accessories,
such as license plate molding or
sticker, on the sensor area. Nor
arbitrarily replace the bumper.
Those may adversely affect the
sensing performance.
• Always keep the sensor/bumper
area clean.
• Use only soft clothes to wash
the vehicle. Also, do not spray
highlypressurized water on the
sensor installed on the bumper.
• Be careful not to apply
unnecessary force on the frontal
sensor area. When the sensor
moves out of the correct position
due to external force, the system
may not normally operate even
without the warning light or
message. In this case, have the
vehicle inspected by a professional
workshop. Kia recommends to
visit an authorized Kia dealer/
service partner.
• Use only the genuine Kia sensor
cover. Do not arbitrarily apply
paint on the sensor cover.
• Do not tint the window or install
stickers, accessories around the
inside mirror where the camera is
installed.
• Make sure the frontal camera
installation point does not get wet.