Maintenance
66
7
4. Remove the headlight bulb cover by
turning it counterclockwise.
5. Disconnect the headlight bulb socket-
connector.
6. Unsnap the headlight bulb retaining
wire by depressing the end and push-
ing it upward. (if equipped)
7. Remove the bulb from the headlight
assembly.
8. Install a new headlight bulb and snap
the headlight bulb retaining wire into
position by aligning the wire with the
groove on the bulb.
9. Connect the headlight bulb socket
connector.
10. Install the headlight bulb cover by
turning it clockwise.
11. Connect the power connector to the
back of the headlight assembly.
12. Reinstall the headlight assembly to
the body of the vehicle.
Turn signal light
1. Remove the headlight assembly from
the body of the vehicle.
2. Remove the socket from the assembly
by turning the socket counterclockwise
until the tabs on the socket align with
the slots on the assembly.
3. Remove the bulb from the socket by
pressing it in and rotating it counter-
clockwise until the tabs on the bulb
align with the slots in the socket. Pull
the bulb out of the socket
4. Insert a new bulb by inserting it into
the socket and rotating it until it locks
into place.
OYN079029
OYN079050
YN RHD 7.QXP 11/20/2014 6:45 PM Page 66