Kia Stinger 2019, Owner'S Manual, Page: 492 / 671

36 6
Checking the tyre inflation
pressure
1.After driving approximately 7~10
km (4~6 miles or about 10 min-
utes), stop at a suitable location.
2.Connect the filling hose (3) of the
compressor (clip mounted side)
directly and then connect the filling
hose (3) (opposite side) to the tyre
valve.
3.Connect between compressor and
the vehicle power outlet using the
cable and connectors.
4.Adjust the tyre inflation pressure to
200 kPa (29 psi). With the Engine
Start/Stop button ON position, pro-
ceed as follows.
- To increase the inflation pres-
sure: Switch on the compressor,
position I. To check the current
inflation pressure setting, briefly
switch off the compressor.
- To reduce the inflation pres-
sure: Press the button (9) on the
compressor.
What to do in an emergency
WARNING
Do not let the compressor run
for more than 10 minutes, other-
wise the device will overheat
and may be damaged.
CAUTION
If the inflation pressure is not
maintained, drive the vehicle a
second time,
refer to
Distributing the sealant. Then
repeat steps 1 to 4.
Use of the TMK may be ineffec-
tual for tyre damage larger than
approximately 4 mm (0.16 in).
Contact a professional work-
shop if the tyre cannot be made
roadworthy with the Tyre
Mobility Kit. Kia recommends to
visit an authorised Kia
dealer/service partner.
WARNING
The tyre inflation pressure must
be at least 200 kPa (29 psi, 2 bar).
If it is not, do not continue driv-
ing.
Call for road side service or
towing.